ATL Telecom AM30 - Manual (Page 17)

ATL Telecom User Guide
AM30
1
7
Step 2. Connect the Ethernet cable.
If you are connecting a LAN to the ADSL/Ethernet router, attach one end of a provided Ethernet
cable to a regular hub port and the other to the Ethernet port on the ROUTER.
If you are using the ROUTER with a single computer and no hub, you must use a “crossover”
Ethernet cable (not provided) to attach the PC directly to the device. The crossover cable is wired
differently than the cable you would use to connect to a hub. When you compare the colored
wires on each end of a straight-through cable, they will be in the same sequence; on crossover
cables, they will not. Contact your ISP for assistance.
Step 3. Attach the power connector.
Connect the AC power adapter to the PWR connector on the back of the device and plug
in the adapter to a wall outlet or power strip.
Step 4. Turn on the ROUTER and power up your systems.
Press the Power switch on the back panel of the device to the ON position.
Turn on and boot up your computer(s) and any LAN devices such as hubs or switches.
Step 5: Install USB software and connect the USB cable.
You can attach a single computer to the device using a USB cable. The USB port is useful if
you have a USB-enabled PC that does not have a network interface card for attaching to
your Ethernet network.
Before attaching the USB cable, you must install a USB driver on your PC and configure the
computer. For complete instructions, see page 25.