ATL Telecom AM30 - Manual (Page 32)

32 ATL Telecom User Guide
AM30
Testing Your Setup
The Quick Start process should enable any computer on your LAN to use the ROUTER’s
ADSL connection to access the Internet.
To test the connection, turn on the device, wait about 30 seconds, and then verify that its
LEDs are illuminated as shown in Table 2.
Table 2. LED Indicators
LED Behavior
PWR Solid green to indicate that the device is turned on. If this
light is not on, check the power cable attachment.
LINK LAN Solid green to indicate that the device can communicate
with your LAN.
LINK WAN Solid green to indicate that the device has successfully
established a connection with your ISP.
If the LEDs illuminate as expected, test your Internet connection from a LAN computer (and
from the USB computer, if applicable): Open your web browser, and type the URL of any
external website (such as
http://www.yahoo.com ). The LED labeled WAN ACT should be
blinking rapidly and may appear solid as the device connects to the site.
If the LEDs do not illuminate as expected or the web page does not display, see Appendix 0
for troubleshooting suggestions. Or, contact your ISP for assistance.