ATL Telecom AM30 - Manual (Page 78)

78 ATL Telecom User Guide
AM30
Figure 39. NAT Rule – Add Page (Pass Flavor)
The Pass rule must be assigned a rule ID that is a lower number than the ID assigned to the
rule it is intended to pass. In you want a specific IP address or range of addresses to not be
subject to an existing rule, say rule ID #5, then you can create a Pass rule with ID #1
through #4.
Follow these instructions to add a Pass rule (see steps 1-4 under "The NAPT rule" on page
68 for detailed instructions corresponding to steps 1 and 2 below):
1. Display the NAT Rule – Add Page, select PASS as the Rule
Flavor, and enter a Rule ID.
2. Select the interface on which this rule will be effective.
3. In the Local Address From and Local Address To fields, type
the lowest and highest IP addresses that define the range of
private address you want to be passed without translation.
If you want the Pass rule to act on only one address, type
that address in both fields.
4. Follow steps 7-12 under "The NAPT rule" on page 68 to
submit your changes.