Loop through on k2 summit/solo, Ports used by k2 services – Grass Valley K2 System Guide v.9.0 User Manual
Page 46
Loop through on K2 Summit/Solo
The Player/Recorder application has a “E-to-E (LoopThru) mode” selection on the Control menu.
This mode applies when the channel is under local AppCenter control as well as when it is under
remote control, for all protocols.
This “E-to-E (LoopThru) mode” feature allows you to monitor the video that is being recorded. The
video is routed back essentially untouched. Any audio or timecode that is on the input video stream
is still there on the loop through output. The K2 Summit/Solo system and the loop through videos
must be locked to a video reference for the loop through feature to work properly. This “E-to-E
(LoopThru) mode” feature should not be confused with true E to E. True E to E is not supported on
the K2 Summit/Solo system.
When “E-to-E (LoopThru) mode” is not selected, the channel behaves as follows:
•
“PB” is displayed on the channel pane, next to the Timecode Source indicator.
•
When no clip is loaded, black plays out.
•
When a record operation stops, Recorder becomes Player and the clip remains in the Player. The
clip’s last frame plays out.
When “E-to-E (LoopThru) mode” is selected, the channel behaves as follows:
•
“EE” is displayed on the channel pane, next to the Timecode Source indicator.
•
When no clip is loaded, the signal that is currently present at the channel input plays out.
•
When a record operation stops, Recorder stays Recorder and the clip remains in the Recorder.
The signal that is currently present at the channel input plays out.
Ports used by K2 services
The following ports are used by the applications and system tools of the K2 family of products:
TCP: Used by mpgsession.exe, mxfsession.exe, gxfsession.exe, or ftpd.exe for FTP.
20
TCP: Used by ftpd.exe for FTP data.
21
UDP: Used by snmp.exe for SNMP.
161
UDP: Used by snmptrap.exe for SNMP trap.
162
TCP: Used by Remote Desktop for use by SiteConfig.
3389
TCP: Used by Grass Valley AppService for 3rd party applications to communicate
using AMP protocol. Used by SDB and XMOS Server AMP Communication.
3811
HTTP: Used by STRATUS Summit Services.
8080
HTTP: Used by Macintosh systems for the SabreTooth licensing web service to
check out licenses
8100
HTTP: Used by Site Config data service .
8732
HTTP: Used by K2 Config data service .
8733
HTTP: Used by Site Config data service .
8734
HTTP: Used by K2 Config data service.
8735
46
K2 System Guide
06 November 2012
Product description