Yaskawa L1000E AC Drive Technical Manual for CIMR-LE Models for Elevator Applications - Manual (Page 189)

5.6 F: Option Settings
YASKAWA ELECTRIC SIEP YAIL1E 01A YASKAWA AC Drive L1000E Technical Manual 189
P
a
ra
me
te
r De
ta
ils
5
■ F1-52: Communication Speed of Serial Encoder Selection
Selects the speed for serial communication between a PG-F3 option card and serial encoder.
Setting 0: 1M bps / 9600 bps (EnDat 2.2/22 / Hiperface)
Setting 1: 500k bps / 19200 bps (EnDat 2.2/22 / Hiperface)
Setting 2: 1M bps / 38400 bps (EnDat 2.2/22 / Hiperface)
Setting 3: 1M bps / 38400 bps (EnDat 2.2/22 / Hiperface)
■ F1-63: PG-E3 R Track Selection
Enables or disables the R phase when a PG-E3 option card is used.
Setting 0: Disabled
The R track is not used. The rotor magnet position is calculated from the C and D track signal only.
Setting 1: Enabled
The R track signals are used to determine the rotor magnet position.
■ F1-66 to F1-81: Encoder Adjust 1 to 16
Sets encoder offsets 1 to 16 for the PG-E3 option card. These parameters are automatically set by the execution of Auto-
Tuning of PG-E3 encoder characteristics.
◆ F3: Digital Input Card Settings
These parameters set up the drive for operation with the option card DI-A3. Refer to the instruction manual packaged
with the option card for specific details on installation, wiring, input signal level selection, and parameter setup.
■ F3-01: DI-A3 Option Card Input Selection
Determines the type of input for digital option card DI-A3 when o1-03 is set to 0 or 1.
Setting 0: BCD, 1% units
Setting 1: BCD, 0.1% units
Setting 2: BCD, 0.01% units
Setting 3: BCD, 1 Hz units
Setting 4: BCD, 0.1 Hz units
Setting 5: BCD, 0.01 Hz units
Setting 6: BCD, special setting (5 digit input), 0.02 Hz units
Setting 7: Binary
The unit and the setting range are determined by F3-03.
F3-03 = 0: 255/100% (-255 to +255)
F3-03 = 1: 4095/100% (-4095 to +4095)
F3-03 = 2: 30000/100% (-33000 to +33000)
No. Parameter Name Setting Range Default
F1-52 Communication Speed of Serial Encoder Selection 0 to 3 0
No. Parameter Name Setting Range Default
F1-63 PG-E3 R Track Selection 0, 1 0
No. Parameter Name Setting Range Default
F1-66 to F1-81 Enoder Adjust 1 to 16 0 to FFFF 0
No. Parameter Name Setting Range Default
F3-01 DI-A3 Option Card Input Selection 0 to 7 0