Yaskawa L1000E AC Drive Technical Manual for CIMR-LE Models for Elevator Applications - Manual (Page 385)

B.3 Parameter Table
YASKAWA ELECTRIC SIEP YAIL1E 01A YASKAWA AC Drive L1000E Technical Manual 385
Pa
ra
met
er
L
is
t
B
A Up/Down Command Source
Open: The Up/Down command is supplied by an external reference (set in b1-02).
Closed: Digital operator supplies the Up/Down command.
201
B Torque Detection 1
Closed: An overtorque or undertorque situation has been detected.
202
E Fault
Closed: Fault occurred. (excluding CPF00 and CPF01)
202
F Not used (Through Mode)
Set this value when the terminal is not used or when using the terminal in the pass-through mode.
202
10 Minor Fault
Closed: An alarm has been triggered, or the IGBTs have reached 90% of their expected life span.
202
11 Fault Reset Command Active
Closed: The drive has received a reset command from the multi-function input terminals or from serial network, or the
digital operator’s RESET key has been pressed.
202
12 Timer Output
Closed: Timer output.
202
13 Speed Agree 2
Closed: When drive output frequency equals the speed reference ±L4-04.
202
14 User-set Speed Agree 2
Closed: When the drive output speed is equal to the value in L4-03 ±L4-04.
203
15 Speed Detection 3
Closed: When the drive output speed is less than or equal to the value in L4-03 ±L4-04.
203
16 Speed Detection 4
Closed: When the output speed is greater than or equal to the value in L4-03 ±L4-04.
204
18 Torque Detection 2
Closed: Overtorque or undertorque has been detected.
202
1A During Down Direction
Closed: Drive is running in the down direction.
204
1B During Baseblock 2 (N.C.)
Open: Drive has entered the baseblock state (no output voltage).
204
1C Motor 2 Selection
Open: Motor 1 is selected
Closed: Motor 2 is selected
205
1D During Regeneration
Closed: Motor is operated in regenerative mode.
205
1E Reset Enabled
Closed: An automatic reset is performed
205
1F Motor Overload Alarm (oL1)
Closed: oL1 is at 90% of its trip point or greater. An oH3 situation also triggers this alarm.
205
20 Drive Overheat Pre-alarm (oH)
Closed: Heatsink temperature exceeds the parameter L8-02 value.
205
2F Maintenance Period
Closed: Cooling fan, electrolytic capacitors, IGBTs, or the soft charge bypass relay may require maintenance.
205
30 During Torque Limit
Closed: When the torque limit has been reached.
205
33 Within Position Lock Bandwidth
Closed: Position deviation is within the Position Lock Bandwidth.
205
H2 Multi-Function Digital Output Settings
H2-††
Setting
Function Description Page
common
_ All Modes
All Modes
common
_
All Modes
common
_
All Modes
common
_
All Modes
common
_
All Modes
common
_
All Modes
common
_
All Modes
common
_
All Modes
common
_
common
_ All Modes
All Modes
common
_
All Modes
common
_
All Modes
common
_
All Modes
common
_
common
_ CLV CLV/PM V/f OLV
common
_ CLV CLV/PM V/f OLV
All Modes
common
_
common
_ All Modes
All Modes
common
_
All Modes
common
_
common
_ CLV CLV/PM V/f OLV
common
_ CLV CLV/PM V/f OLV