ProSoft Technology 5201-DFNT-104S - Manual (Page 112)

104S v2 ♦ ProLinx Gateway Reference
(Firmware v2.xx) Protocol Manual
Page 112 of 157
ProSoft Technology, Inc.
Two block IDs per command type are required to allow the detection of a new
block. So the remote node can switch between two block IDs when a new
command block for the same type is requested. Even if the block only contains a
request with response type, then offsets 0 and 99 must also trigger to a new
value to allow the gateway to detect a new block. Follows below some examples
to illustrate this functionality. This section will not cover each block structure but
will only cover the block transfer mechanism. For these examples consider the
default configuration settings:
March 19, 2010