ProSoft Technology 5201-DFNT-104S - Manual (Page 131)

Reference 104S v2 ♦ ProLinx Gateway
Protocol Manual (Firmware v2.xx)
ProSoft Technology, Inc.
Page 131 of 157
March 19, 2010
Parameter in control direction
(Station-specific parameter, mark each Type ID 'X" if it is only used in the
standard direction, "R" if only used in the reverse direction, and "B" if used in
both directions)
⌧
<110> := Parameter of measured value, normalized value P_ME_NA_1
⌧
<111> := Parameter of measured value, scaled value P_ME_NB_1
⌧ <112> := Parameter of measured value,
short floating point value P_ME_NC_1
<113> := Parameter activation P_AC_NA_1
File transfer
(Station-specific parameter, mark each Type ID "X" if it is only used in the
standard direction, "R" if only used in the reverse direction, and "B" if used in
both directions)
<120> := File ready F_FR_NA_1
<121> := Section ready F_SR_NA_1
<122> := Call directory, select file, call file, call section F_SC_NA_1
<123> := Last section, last segment F_LS_NA_1
<124> := Ack file, ack section F_AF_NA_1
<125> := Segment F_SG_NA_1
<126> := Directory F_DR_TA_1
5.7.4 Type identifier and cause of transmission assignments
(Station-specific parameters)
Shaded boxes: option not required
Black boxes: option not permitted in this companion standard
Blank boxes: functions or ASDU not used
Mark Type Identification/Cause of Transmission combinations: 'X" if only used in
standard direction, "R" if only used in reverse direction, and "B" if used in both
directions