ProSoft Technology 5201-DFNT-104S - Manual (Page 32)

104S v2 ♦ ProLinx Gateway Configure the Gateway
(Firmware v2.xx) Protocol Manual
Page 32 of 157
ProSoft Technology, Inc.
March 19, 2010
2.1.11 [M_IT_NA_1 104]
This section defines the monitored integrated totals (counter) database for the
server emulated. This information is sourced from the database and is
transferred to the remote client unit.
This section takes the following parameters:
Point #:
DB Address:
Group(s):
IV DB Bit
Each point is two, 16-bit words and the DB Address value corresponds to the
double-word offset in the gateway memory database. For additional information
on how to set these parameters, see the 104S Tutorial and Reference chapters
of this manual.
2.1.12 [C_SC_NA_1 104]
This section defines the single point command database for the server emulated.
This information is sourced from the remote client and is transferred to the
database. You can associate a command with a monitored single-point database
value to coordinate the command/monitor operation. You must enter the correct
Monitor Point # and Monitor DB Address values in the table. If the Require Select
parameter is not set to zero, a select command must be received before an
execute command will be processed.
This section takes the following parameters:
Point #:
DB Address:
Monitor Point #:
Monitor
DB Addr:
Require Select:
Each point is one bit and the DB Address value corresponds to the bit offset in
the gateway memory database. For additional information on how to set these
parameters, see the 104S Tutorial and Reference chapters of this manual.