ProSoft Technology 5201-DFNT-104S - Manual (Page 66)

104S v2 ♦ ProLinx Gateway IEC-60870-5-104 (104S) Protocol Implementation
(Firmware v2.xx) Protocol Manual
Page 66 of 157
ProSoft Technology, Inc.
The protocol specification defines a qualifier value that is set by the master to
determine the duration of the pulse (short, long or persistent). Configure the
parameters below to set the duration of the short and long pulses:
C_RC_NA
A Step-Point Command point occupies one byte and uses byte-addressing.
For example, if you configured the following points:
The following table describes how these points would be used.
March 19, 2010