ProSoft Technology 5201-DFNT-104S - Manual (Page 26)

104S v2 ♦ ProLinx Gateway Configure the Gateway
(Firmware v2.xx) Protocol Manual
Page 26 of 157
ProSoft Technology, Inc.
Point Count
Point Count configuration ranges in the following configuration items are based
on the assumption that you will be using only one of the available data types for
your application. The number of point counts you configure will have an effect on
gateway performance, in particular the accuracy of the gateway’s internal clock.
M_SP_NA point count: This parameter specifies the number of point values
assigned for the monitored single-point database. Range is 0 to 1000.
M_DP_NA point count: This parameter specifies the number of point values
assigned for the monitored dual-point database. Range is 0 to 1000.
M_ST_NA point count: This parameter specifies the number of point values
assigned for the monitored step-point database. Range is 0 to 1000.
M_ME_NA point count: This parameter specifies the number of point values
assigned for the monitored normalized-point database. Range is 0 to 1000.
M_ME_NB point count: This parameter specifies the number of point values
assigned for the monitored scaled-point database. Range is 0 to 1000.
M_ME_NC point count: This parameter specifies the number of point values
assigned for the monitored scaled short-float point database. Range is 0 to
50.
M_IT_NA point count: This parameter specifies the number of point values
assigned for the monitored counter-point database. Range is 0 to 99.
C_SC_NA point count: This parameter specifies the number of point values
assigned for the command single-point database. Range is 0 to 1000.
C_DC_NA point count: This parameter specifies the number of point values
assigned for the command dual-point database. Range is 0 to 1000.
C_RC_NA point count: This parameter specifies the number of point values
assigned for the command step-point database. Range is 0 to 1000.
March 19, 2010