ProSoft Technology 5201-DFNT-104S - Manual (Page 135)

Reference 104S v2 ♦ ProLinx Gateway
Protocol Manual (Firmware v2.xx)
ProSoft Technology, Inc.
Page 135 of 157
March 19, 2010
Supervision of maximum delay in command direction of commands and
set point commands
Maximum allowable delay of commands and set point commands
Transmission of Integrated totals
(Station- or object-specific parameter, mark "X" if function is only used in the
standard direction, "R" if only used in the reverse direction, and "B" if used in
both directions)
⌧
Mode A: Local freeze with spontaneous transmission
Mode B: Local freeze with counter interrogation
Mode C: Freeze and transmit by counter-interrogation commands
⌧ Mode D: Freeze by counter-interrogation command, frozen values
reported spontaneously
⌧ Counter
read
⌧ Counter freeze without reset
Counter freeze with reset
Counter reset
⌧ General request counter
⌧ Request counter group 1
⌧ Request counter group 2
⌧ Request counter group 3
⌧ Request counter group 4
Parameter loading
(Object-specific parameter, mark "X" if function is only used in the standard
direction, "R" if only used in the reverse direction, and "B" if used in both
directions)
⌧ Threshold
value
Smoothing factor
⌧ Low limit for transmission of measured value
⌧ High limit for transmission of measured value
Parameter activation
(Object-specific parameter, mark "X" if function is only used in the standard
direction, "R" if only used in the reverse direction, and "B" if used in both
directions)
Act/deact of persistent cyclic or periodic transmission of the addressed
object