Roland V-8HD HDMI Video Switcher and UVC-01 USB Capture Device Kit - Manual (Page 58)

58
Other Features
Loading
Here’s how to load the sequencer settings that are saved on a USB
flash drive. When you load settings, the current sequencer settings
are overwritten.
1 . Press the [MENU] button 0 “SEQUENCER” 0 select
“LOAD FROM USB MEMORY”, and press the [VALUE]
knob.
The sequence files in the USB flash drive are listed.
2 . Use the [VALUE] knob to select the sequence file
that you want to load, and press the [VALUE] knob.
A confirmation message appears.
* If you decide to cancel, press the [EXIT] button.
3 . Use the [VALUE] knob to select “YES”, and press the
[VALUE] knob.
The sequencer settings are loaded. When the operation is finished,
the message “COMPLETE” appears.
4 . Press the [MENU] button to close the menu.
Initializing the Sequencer
Here’s how to initialize the sequencer and erase all the settings.
1 . Press the [MENU] button 0 “SEQUENCER” 0 select
“INITIALIZE”, and press the [VALUE] knob.
A confirmation message appears.
* If you decide to cancel, press the [EXIT] button.
2 . Use the [VALUE] knob to select “YES”, and press the
[VALUE] knob.
The sequencer is initialized. When the operation is finished, the
message “COMPLETE” appears.
3 . Press the [MENU] button to close the menu.
MEMO
About the sequencer demo data
Once you perform a factory reset (p. 64), any demo data you
have edited or deleted is restored to its factory default settings.