Roland V-8HD HDMI Video Switcher and UVC-01 USB Capture Device Kit - Manual (Page 64)

64
Other Features
Controlling an External Recorder’s Video
Record Start/Stop from the V-8HD
If a recorder that supports the “HDMI REC TRIGGER” function is
connected to an OUTPUT of the V-8HD, you can use the USER [1] or
[2] button of the V-8HD to control video record start/stop on that
recorder.
For more about recorders that support the HDMI REC TRIGGER
function, refer to the Roland website.
https://proav .roland .com/
1 . Press the [MENU] button 0 “SYSTEM” 0 select
USER 1 SW or USER 2 SW “CATEGORY”, and press the
[VALUE] knob.
2 . Use the [VALUE] knob to select “REC CONTROL”, and
press the [VALUE] knob.
3 . Press the [MENU] button to quit the menu.
4 . Press the USER [1] or [2] button that is assigned to
“REC CONTROL”.
Each time you press the button, the recorder switches between
video record start/stop.
The USER [1] or [2] button is lit red during recording, and is unlit
when recording stops.
MEMO
5 The lit/unlit state of the USER [1] [2] buttons indicates the state
of the V-8HD, and does not reflect the state of the external
recorder.
This means that even if, while the USER [1] or [2] button is
lit red, the external recorder stops recording because of an
operation performed on it or because of the state of its storage,
the USER [1] or [2] button does not go dark at that time.
5 If you want to disable control of the recorder that supports
the HDMI REC TRIGGER function, turn the VIDEO OUTPUT
menu 0 OUTPUT 1–3 “REC CONTROL” setting “OFF”.
Returning to the Factory Settings
(Factory Reset)
Here’s how you can return the settings of the V-8HD to their factory-
set state. If following the procedures described in this manual does
not cause the result you expect, try executing a factory reset.
NOTE
5 When you execute factory reset, any previously specified
content, any settings saved in preset memory (p. 41), and
the still image (p. 29) saved in the unit will all be lost.
5 Do not turn off the power while the “PLEASE WAIT” message
is shown.
1 . Press the [MENU] button 0 “SYSTEM” 0 select
“FACTORY RESET”, and press the [VALUE] knob.
A confirmation message appears.
* If you decide to cancel, press the [EXIT] button.
2 . Use the [VALUE] knob to select “YES”, and press the
[VALUE] knob.
The factory reset is executed.
When the operation is finished, the message “COMPLETE” appears.
3 . Press the [MENU] button to quit the menu.