Roland V-8HD HDMI Video Switcher and UVC-01 USB Capture Device Kit - Manual (Page 60)

60
Other Features
Recalling
This loads settings that are in a preset memory saved on a USB flash
drive. Loading settings overwrites the preset memory on the unit.
1 . Press the [MENU] button 0 “USB MEMORY” 0
select “RESTORE ALL SETTINGS”, and press the
[VALUE] knob.
2 . Use the [VALUE] knob to select the file you want to
recall, and press the [VALUE] knob.
A confirmation message appears.
* If you decide to cancel, press the [EXIT] button.
3 . Use the [VALUE] knob to select “YES”, and press the
[VALUE] knob.
The settings are recalled, and the values in the unit’s preset
memories are overwritten.
4 . Press the [MENU] button to quit the menu.
Formatting USB Flash Drives
When using a USB flash drive for the first time, be sure to format it on
the V-8HD.
NOTE
5 You may not be able to normally use USB flash drives on the
V-8HD that are formatted on a different device. Be sure to
format the media on the V-8HD (in FAT32 format).
* Depending on the original format, formatting the USB flash
drive might take some time.
If an error message like “USB memory not ready” is shown,
format the media on the V-8HD so that you can use it.
5 Performing formatting causes all data already saved on
the USB flash drive to be deleted. If the ash drive contains
necessary data, back it up onto a computer or elsewhere
before formatting the drive.
1 . Connect the USB flash drive to the USB MEMORY
port.
2 . Press the [MENU] button 0 “USB MEMORY” 0
select “FORMAT”, and press the [VALUE] knob.
A confirmation message appears.
* If you decide to cancel, press the [EXIT] button.
3 . Use the [VALUE] knob to select “YES”, and press the
[VALUE] knob.
Formatting of the USB flash drive is carried out.
4 . Press the [MENU] button to quit the menu.