High End Systems High End LCD Controller for Studio Color - Manual (Page 106)

4-22 Preset Programming Studio Color LCD Controller
Recording a Loop as a Preset
Start the loop running, then assign the entire loop to one of
the Preset keys. For more information about loops, see the
section titled “Creating a Loop” on page 4-14.
1. Use the Page <Up> and <Down> arrow keys to select any page
within the loop that you want to record as a preset.
2. Toggle the <Address>/<Preset> key until the Address LED is
ON.
3. Press the <Auto> key. The pages start advancing, playing
back the loop at the rate set by the <Rate> knob and the Delay
construct.
4. Toggle the <Address>/<Preset> key until the Preset LED is
ON. The LCD display then appears as shown below:
5. Use the Cursor <Right> and <Left> arrow keys to select a bank
of presets. Each bank contains 8 presets.
6. Press the <Select> key. The Select LED flashes and the LCD
display appears as shown below:
7. Press the Preset key ( <1> to <8> ) on the front panel to store
the loop. See Figure 4-5 on page 4-20 for an explanation of
how preset bank numbering works.
8. Optional. If you are using 12-level preset access, follow the
instructions in the section titled “Using Twelve-Level Preset
Access” on page 6-19.
9. Adjust the following settings; these settings are recorded as
part of the preset (you can change them later).
PRESET
ADDRESS
PRESET
ADDRESS
7
 
#88  
#+  -
*#+
& ,?
#+ + @"
;)
  

 
  *  3-  <
 ;0 :
'