High End Systems High End LCD Controller for Studio Color - Manual (Page 208)

G-12 Glossary Studio Color LCD Controller
Standby
In Standby, all fixtures’ shutters close and any in-progress
wheel or effect changes stop immediately. Controller pages
continue to advance in Standby, however.
You can put the controller into Standby by pressing the
<Standby> key on the controller’s front panel.
See also “Remote Enable”.
Studio Color Upload Module
(Also called a dongle.) Allows you to upgrade firmware to
Studio Color fixtures across a DMX 512 link. All you need is
a computer with an available parallel port and keyboard
connector. Contact your High End Systems dealer/distributor
for more information (part number 26040002).
Studio Color fixtures need to be running firmware version
38C or later in order to take full advantage of available
constructs. The section titled “Verifying the Firmware
Version” on page 2-9 explains how to check the firmware
version.
Submaster
A submaster is an analog 0-10 V controller you can use to
remotely adjust (override), in real time, the dim, color, and
gobo construct parameters for selected fixtures. You can
define up to 12 submasters and control them using one or
more analog controllers.
Tip/Ring connector
The type of connector typically used for monaural audio
sources. A connector of this type is shown in Figure 6-6 on
page 6-30.
Tip/Ring/Sleeve connector
The type of connector typically used for stereo audio sources.
This type of connector is diagrammed above the Stereo
Audio Input port located on the controller’s rear panel.