High End Systems High End LCD Controller for Studio Color - Manual (Page 29)

Studio Color LCD Controller Setting the Controller Voltage 1-7
1
Setting the Controller Voltage
At the time of this writing, the Studio Color LCD controller is
shipped from the factory set to 230V. Carefully examine the
controller’s voltage setting (as shown in Figure 1-1 on page
1-9), then follow the instructions in this section if you need to
change it.
Warnings (1) Check the voltage selection switch
before proceeding with the equipment
setup! Be sure to match the voltage
selection switch to your power source
prior to operating this equipment. Do not
set the voltage selection switch with the
equipment plugged in.
(2) Before selecting a voltage, you should
verify the correct voltage setting with a
local authority. Selecting an incorrect
voltage will result in an electric shock
hazard and can cause injury to persons as
well as damage the fixture. High End
Systems, Inc. can accept no responsibility
for damage to your controller or other
equipment caused by an incorrect voltage
setting.