High End Systems High End LCD Controller for Studio Color - Manual (Page 155)

Studio Color LCD Controller Submasters 6-25
6
Assigning a Channel for Master Dim
This section explains how to use a submaster as the “master
dim controller”. Once you assign a channel for master dim,
the same channel cannot be used to control fixtures. For
example, if you select channel 1 for master dim, you cannot
use channel 1 to control fixtures.
Note When the master dim is assigned to a channel, you
should not use the Studio Color LCD controller for
master dim control; master dim should be controlled
by the submaster “master dim controller”.
1. Select
;

from the Main menu, as shown below:
2. Press the Cursor <Down> arrow key. The LCD display then
appears similar to the one shown below:
3. Use the Construct <Up> and <Down> arrow keys to select a
channel for master dim. Remember that the channel you
assign to master dim cannot also be assigned as a submaster.
4. After you set the channel for master dim, you can assign
submaster channels as shown in the next section.
Assigning Fixtures to a Submaster
To have a particular submaster control the dimming or color
of a particular fixture(s), you have to assign that fixture(s) to
that submaster. There are 12 submasters available (or eleven
if you assigned one channel to master dim).
)
;?
;:; 
(

-   D ( 
(

1
;:4+ $ 2 . % J K @ 8 +5 ++ +$
/
! 
)
*