High End Systems High End LCD Controller for Studio Color - Manual (Page 58)

2-24 Other Connectors Studio Color LCD Controller
Remote Enable port: Use the Remote Enable signal to
enable and disable the controller from a remote location.
Connect a shielded 2-conductor cable with a 3.5 mm (1/8”) tip/
ring connector to the controller’s mini-microphone jack and
use it as follows:
• 0 volts DC disables the controller (all fixtures go dark
and all in-progress wheel and effects moves finish
immediately)
• 5 volts DC (minimum) to 16 volts DC (maximum) to
enable the controller (return it to its previous state of
operation)
For more details about the usage of this port, see the section
titled “Remote Enable” on page 6-30.
Stereo Audio Input port: Connect a shielded 2-conductor
cable with a 6mm (1/4inch) tip/ring/sleeve connector to this
port to control Studio Color fixture audio playback from a
stereo source. Sensitivity to the audio signal is controlled
from the front panel of the controller using the
<Audio> knob.
For more details about the usage of this port, see the section
titled “Audio Input Playback” on page 6-27.