High End Systems High End LCD Controller for Studio Color - Manual (Page 79)

Studio Color LCD Controller Using the Construct Keys 3-17
3
Lens 2 has the following effects:
• Beam shaping: A long, narrow beam rotates into a
short, fat beam. Construct values between approximately
100 (39%) and 220 (86%) select beam shaping. (Values
above about 220 or 86% move toward the open position.)
• Frost: The “effect” position is frost—soft, undefined
beam edges. Values between below approximately 100
(39%) select frost.
Note The transition time of this construct is set using the
XFade construct as described in the section titled
“Xfade Key” on page 3-14.
Mode Key
Allows you to select color mixing options: normal or double.
Normal color mixing means the values of the Red, Green or
Blue constructs (0—255) correspond directly to the resulting
color. Use this choice to achieve gradual color changes with
the full spectrum of available colors.
Double color mixing is useful to achieve faster (or snap)
color changes but limits your available colors. Values of 0—
255 for Red, Green or Blue constructs give you two full
cycles (from 0% color to 100%) of the selected color. A
value of 0 is zero intensity for the color; a value of about 122
(48%) is full intensity, a value of about 140 (55%) is zero
intensity and a value of 255 is full intensity.
Follow the procedure below to see how this works:
1. Use the Page <Up> and <Down> arrow keys to select a page
that has not been programmed yet.
2. Toggle the <Standby> key until the Standby LED turns OFF.
3. Press the <Select> key and then press the Address keys
corresponding to one or more fixtures.