High End Systems High End LCD Controller for Studio Color - Manual (Page 150)

6-20 Remote Preset Access Studio Color LCD Controller
audio 1 and 2 advance (page 6-27), color modulate (page
6-27) and dim modulate (page 6-27) as needed. These
settings are stored with the preset.
9. Press the <Record> key. The Select LED stops flashing,
indicating the preset is now recorded.
Note If enabling analog controller channels does not call up
presets in memory, make sure there are no submasters
assigned. See the section titled “Submasters” on page
6-23.
Playing Back in Twelve-Level Preset Access
1. Enable the analog controller channel corresponding to the
preset level you wish to access. For example, to access one
of the first level of eight presets, enable analog controller
channel 1. To access one of the second level of eight presets
(9 through 16), enable controller channel 2.
Note The highest-numbered channel takes precedence if
you simultaneously enable two channels.
0V = Disabled
5V-10V = Enabled
2. Toggle the <Address>/<Preset> key on the Studio Color LCD
controller until the Preset LED is ON.
3. Press one of the eight Preset keys on the Studio Color LCD
controller’s front panel to play back that preset.
4. The preset continues to play back until you:
• press another Preset key
• change to another preset level by activating another
channel on the controller
• press the <Standby> key until the Standby LED comes
ON
• manually change the memory or page