High End Systems High End LCD Controller for Studio Color - Manual (Page 194)

7-32 Crossloading Studio Color LCD Controller
Consult Appendix C for a complete selection of cabling and
connector wiring diagrams.
Crossload Procedure
The source controller is the one you want to transfer data
from; the destination controller is the one you want to
transfer data to.
1. Toggle the <Standby> keys on each controller until their
Standby LEDs come ON.
2. Press and hold the <Record> key on the source controller
(about 10 seconds) until its LCD display shows the
following:
3. Press and hold the <Erase> key on the destination controller
(about 10 seconds) until its LCD display shows the
following:
4. Press the <Record> key on the source controller to start the
transfer. While the transfer is taking place, the LCD display
on the destination controller appears similar to the one shown
below:
Note Press the <Select> key on each controller (in any
order) at any time to stop the transfer. No data
corruption will result; stopping the transfer only limits
D )

; $2$ 
-


  ; 77()<
   /
)
(; $2$ 

; ()!D< ;0 :D  
D )

; $2$ 

  *
#'-#''