High End Systems High End LCD Controller for Studio Color - Manual (Page 53)

Studio Color LCD Controller Connecting Fixtures 2-19
2
be linked to a lighting console via its MIDI, RS-232C or
analog ports. Only the master controller (not the slaves) can
accept commands from the lighting console.
The system shown in Figure 2-13 can support up to 24
independently-functioning Studio Color fixtures (8 for each
of the three controllers). Also notice that fixtures are
numbered non-sequentially. The Studio Color LCD
controller recognizes fixtures numbered in any order you
wish, as long as all fixtures are numbered between 1 and 8.
Linking Fixtures to the Controller
1. Start with the controller. Connect 3-pin data-grade XLR
cable to its Data Out connector, as shown in Figure 2-14:
Figure 2-14. Connect the male end of a 3-pin XLR
cable to the controller’s female Data Out port.
2. Connect the female end of the XLR cable from the controller
to the first Studio Color fixture’s male Data In connector.
3. Connect the male end of another XLR cable to the first
Studio Color fixture’s female Data Out connector.
4. Continue connecting the Data Out connector from one Studio
Color to the Data In connector to the next Studio Color until
you have linked all of the Studio Color fixtures. It is not
necessary to connect fixtures in any particular order; connect
them in a way that results in the least amount of cabling.
DATA LINK OUT
CAUTION
WARNING
PERSONA LITY SLAVE MASTER RS-232
SERIAL PORT 1-6
ANALOG INPUTS
7-12
REMOTE ENABLE
FUSE
CAUTION voltage select
1 2 3 4
A B
MIDI
I N OUT STERE O AUD IO INPUT
115
T o reduce the ri sk of fi re or
electr ic shock, do not expose
t hi s device t o rain or m ois tur e.
L
R
IM PORTANT SAFETY INFORM ATION. SEE INSTRUCTION MANUAL BEFORE USE.
WICHTIGE SICHERHEITSINFORMATIONEN. BEDIENUNGSAN LEITUNG VOR GEBRAUCH LESEN!
D'IMPORTANTE CONSIGNE DE SÉCURITÉ. VOYEZ LE MANUEL D'INSTRUCTION AVANT L'UTILISATION DE L'APPAREIL.
This device compli es with part 15 of the FCC rules.
Operation is subject to the following two c onditions:
(1) This device may not cause harmful i nterferences,
and (2) t his device must accept any i nterference
that may cause undesired operation.
To prevent electric shock, do
not remove cover. No user
serviceable parts inside.Refer
servicing to qualified service
personnel. Replace fuse with
same type and rating.
R A T I N G IN F O R MA T IO N
V O LT A G E : 1 15 V A C /2 30V A C
C U R R E N T : 0 .2 5A/ 0 .1 5A
F R EQ U E N C Y: 5 0- 6 0 H Z
115 V 0.5 A, SLOW BLOW
230 V 0.315 A, SLOW BLOW
1 2 3 4 1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
Attach a male 3-pin XLR connector
MODEL
SE RIAL
DA TE QC
VOLTA GE HZ 230
15FM123456 Cyberlight LCD Controller
50
8 0 59 00 01
ETL Listed C onforms to
U L Std. 1950
C er tified to C AN /CSA C 22.2 No. 950 67501
R C R
LIGHTWAVE RESEARCH
2217 West Braker Lane
Austin, Texas U.S.A.