High End Systems High End LCD Controller for Studio Color User Manual
Page 80
3-18
Using the Construct Keys
Studio Color LCD Controller
4.
Press the
<Gate>
key and use the Construct
<Up>
and
<Down>
arrow keys to select
/
.
5.
Use the joystick to direct the beam at a reference point (wall,
screen, or other surface).
6.
Press the
<Mode>
key, then use the Construct
<Up>
and
<Down>
arrow keys to select
) )' *
as shown
below:
7.
Press the
<Green>
key and use the Construct
<Up>
and
<Down>
arrow keys to select a value of
5
.
8.
Press the
<Blue>
key and use the Construct
<Up>
and
<Down>
arrow keys to select a value of
5
9.
The result is a 100% red beam. Press the
<Red>
key and use
the Construct
<Up>
and
<Down>
arrow keys to vary the value
of the construct from 0 to 255. You should see a red beam of
varying intensities.
10. Press the
<Mode>
key and use the Construct
<Up>
and
<Down>
arrow keys to select
) )' *
.
11. Press the
<Red>
key and use the Construct
<Up>
and
<Down>
arrow keys to vary the value of the construct.
•
From 0 to about 122 (48%), the beam rapidly increases in
intensity.
•
The beam reaches a minimum intensity at about 140
(55%).
•
From about 141 (55%) to 255 (FF%), the beam rapidly
increases in intensity again.
12. With the Red construct at full intensity, try varying the Green
and Blue constructs to see the effect on color mixing.
* ) / ,
/# ) )' *-#'