High End Systems High End LCD Controller for Studio Color - Manual (Page 87)

Studio Color LCD Controller Preparing to Program 4-3
4
Preparing to Program
Before beginning any programming, make sure the controller
appears as shown below:
Figure 4-1. Before programming, make sure the
controller’s Address LED is ON, the Select and
Standby LEDs are both OFF, and the controller is
displaying the Intensity, Memory and Page.
Toggle the <Standby> key until the Standby LED turns OFF.
Toggle the <Address> key until the Address LED turns ON.
Toggle the <Menu> key until Intensity, Memory and Page is
showing in the LCD display.
Toggle the <Select> key until the Select LED turns OFF.
ADVANCE
LIGHTWAVE
audio
level
erase record select
home
page cursor construct
PAGE MEMORY INTENSITY
MEMORY CARD
POWER
STANDBY
rat e
USER
auto
PRESET
ADDRESS
1
3
5
7
2
4
6
8
1 2 3 4
5 6 7 8
slave



Studio Color


  
  
  
  
 
   

Address LED on
Standby LED off
Select LED off
LCD display shows Intensity, Memory,
Page
Intensity: 99 Memory: x Page: x