FARGO electronic C16 - Manual (Page 105)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0) 96
Using the Resin Heat (K) option
Use this option to control the amount of heat the Printer uses when printing with the resin
black panel(s) of a full-color ribbon or when printing with a resin-only ribbon by adjusting the
Resin Heat slide.
Step Procedure
1 Move the slide to the left to cause less heat to be used in the printing process,
causing resin images to be lighter or less saturated.
OR
Move the slide to the right to cause more heat to be used.
(Note: This control can be helpful for fine-tuning the transfer of resin text and
bar codes.)