FARGO electronic C16 - Manual (Page 188)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0) 179
Replacing the Upper Ribbon Sensor Assembly (83015111) (continued)
Steps Procedure
14 Use a wire cutting tool to severe the wires of the Ribbon Sensor Assembly, near
the opening of the Head Harness Assembly.
15 Disconnect the Ribbon Sensor cable from J12, pins 3 and 4 on the Print Circuit
Board.
16 Sever the wires of the Ribbon Sensor cable near the opening of the Printhead
Harness Assembly.
17 Take the Ribbons Sensor Board Assembly from the Printer.
18 When reinstalling, route the wires for the new assembly along the same path as
the Head Harness Cable.