Replacing the ribbon drive motor assembly (830147), Refer to drawing 830117-xx – FARGO electronic C16 User Manual
Page 181
RESTRICTED USE ONLY
Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0)
172
Replacing the Ribbon Drive Motor Assembly (830147)
Refer to Drawing 830117-XX
Estimated Repair Time: 15 minutes.
Steps Procedures
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2
Open the Upper Imaging Assembly.
3
Loosen the top two corner screws (130987) found just behind the top edge of
the Rear Cover.
4
Close the Upper Imaging Assembly.
5
Remove the screw (130987) by the Card Exit Ramp.
6
Remove the Rear Cover.
7
Remove the two screws (130971) that secure the Print Circuit Board to the two
Standoff screws (140047).
8
Remove the screws that hold the Main Board Brackets in place.
9
Use the thumb and index fingers of both hands to carefully pry the Print Circuit
Board from the Power Circuit Board.
10
Remove all of the cables from the Circuit Boards.
11
Remove the three screws (130938) from the Ribbon Drive Assembly.
12
Take the Ribbon Drive Assembly from the Printer.
13
Take care to keep the Shaft from binding with the casing of the Ribbon Drive
Assembly before tightening the three screws.