FARGO electronic C16 - Manual (Page 120)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0) 111
Using the Verification radio buttons and Retries selection
Use this option to customize the Encoding verification settings.
Step Procedure
1 Select the Auto Eject 1st Error option to instruct the Printer to verify that all
magnetic data has been correctly encoded on each card. (Note: The Auto Eject
option is the most direct means of dealing with misverified cards; however, it may
be undesirable when dealing with Encoding errors. For this reason, a Manual
Eject Each Error option is also provided.)
• Auto Eject 1st Error option: If the Auto Eject 1st Error option is selected,
the Printer will automatically eject a card containing magnetic data that cannot
be verified and will feed a new card into the Printer. (Note: Only the first
misverified card would be automatically ejected.)
• Manual Eject Mode option: If a second consecutive card cannot be verified,
the Printer will signal an error and go into a Manual Eject Mode. (Note: If the
loaded cards have the wrong type of Magnetic Stripe, the Printer will not
automatically feed and eject the entire card supply.)
OR
Select the Manual Eject Each Error option so that the Printer will signal an error
communicating the magnetic data could not be verified.
• Unverified Magnetic Data: When this occurs, press the Pause/Resume
button to manually eject the misverified card and feed in a new card.
• Retries selection: Specify the number of times the Printer must retry its
verification pass. (Note: A range of 1 to 5 retries can be selected. This option
is helpful since successful Magnetic Stripe verification can sometimes require
more than a single pass.)