Replacing the stepper motor assembly (810113), Refer to drawing 830117-xx – FARGO electronic C16 User Manual
Page 182
RESTRICTED USE ONLY
Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0)
173
Replacing the Stepper Motor assembly (810113)
Refer to Drawing 830117-XX
Estimated Repair Time: 15 minutes.
Steps Procedures
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2
Open the Upper Imaging Assembly.
3
Loosen the top two corner screws (130987) found just behind the top edge of
the Rear Cover.
4
Close the Upper Imaging Assembly.
5
Remove the screw (130987) by the Card Exit Ramp.
6
Remove the Rear Cover.
7
Remove the two screws (130971) that secure the Print Circuit Board to the two
Standoff screws (140047).
8
Remove the screws that hold the Main Board Brackets in place.
9
Use the thumb and index fingers of both hands to carefully pry the Print Circuit
Board from the Power Circuit Board.
10
Remove all of the cables from the Circuit Boards.
11
Loosen the screws that hold the idler plate in place to relieve tension on the
belts.
12
Remove two screws (130938) from the Stepper Motor Assembly that secures
the assembly to the Printer chassis. See the next page.
13
Take the Stepper Motor Assembly from the Printer.