FARGO electronic C16 - Manual (Page 89)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0) 80
The diagram (below) represents how the printed image will move in relation to the fixed card
position as a positive or negative Image Placement value is entered.
Step Procedure
1 Click on the left arrow to enter a positive value to move the printed image
toward the leading edge of the card or the card output to the side of the Printer.
OR
Click on the right arrow to enter a negative value to move the printed image
toward the trailing edge of the card or the card input to the side of the Printer.
• Printed Image Direction: The arrows on these buttons indicate the direction
the printed image will move on the card.
• Maximum Adjustment Range: The maximum adjustment range is ±100. As a
rule, 10 equals about .030"/. 8mm, which is about the same as the thickness of
a standard CR-80 size card.
Caution: If positive value is set too high, the print ribbon may break.
Direction card travels through printer
Rear of Printer
Card Output
Side of Printer
(Leading Edge
of Card)
Card Input
Side of Printer
(Trailing Edge
of Card)
Front of Printer