FARGO electronic C16 - Manual (Page 195)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0) 186
Replacing the Platen Roller (D830023) (continued)
Steps Procedure
9 Use the thumb and index fingers of both hands to carefully pry the Print Circuit
Board from the Power Circuit Board.
10 Stand at the front of the Chassis Assembly; remove the Retaining Ring (140048)
from the Platen Roller Shaft.
11 Remove the Platen Card Drive Gear.
(Note: The wide part of the gear hub faces the Side plate.)
12 Take off the Washer Spring (130951).
(Note: The wave of the spring faces the Platen Card Drive Gear.)
13 Remove the Retaining Ring (140048) from the Platen Roller Shaft on the back of
the Chassis Assembly.
14 Remove the Right Roller Gear (760400).
15 Stand at the front of the Chassis Assembly; remove the two screws (130971)
that secure the Card Guide Assembly. The Card Guide Assembly does not need
to be removed; allow it to “float” so the Platen Roller can be removed from the
chassis.
16 Remove the two Drive Roller Bearings (760343) from the Platen Roller Shaft.
17 Guide the Platen Roller through the access opening in the front Side plate and
out of the Printer.