Replacing the power circuit board (a000284), Refer to drawings 830117, 830118 and 830119, Replacing the printhead – FARGO electronic C16 User Manual
Page 174: Assembly (820199)
RESTRICTED USE ONLY
Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0)
165
Replacing the Power Circuit Board (A000284)
Refer to Drawings 830117, 830118 and 830119.
Estimated Repair Time: 20 minutes.
Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2
Open the Upper Imaging Assembly.
3
Loosen the top two corner screws (130987) found just behind the top edge of
the Rear Cover.
4
Close the Upper Imaging Assembly.
5
Remove the screw (130987) by the Card Exit Ramp.
6
Remove the Rear Cover.
7
Remove the two screws (130971) that secure the Print Circuit Board to the two
Standoff screws (140047).
8
Remove the screws that hold the Main Board Brackets in place.
9
Use the thumb and index fingers of both hands to carefully pry the Print Board
from the Power Board.
10
Remove all of the cables from the Board.
11
Remove the screw (130971) Washer (130949) and Cable Clamp (140013) from
the Power Board.
12
Remove all of the cables from the Power Board.
13
Remove the Power Board.