FARGO electronic C16 - Manual (Page 22)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0) 13
Printer Components: Top Cover to Parallel Interface Card
Components Description
Top Cover This cover opens to allow access to the Printhead, print ribbon and card
path. (Note: This cover must be closed in order for the Printer to begin
printing.)
Release tab This tab unlatches the Top Cover.
Printhead This Printer component actually does the printing. (Note: This
component is fragile and must not be bumped or touched with anything
other than a cleaning pen.)
On/Cancel
button The On/Cancel button turns the Printer ON and OFF. (Note: It also
serves to cancel the current print job and reset the Printer for the next
print job.)
If a card is left within the Printer after a print job is canceled, it will
automatically be ejected when the Printer is turned back ON.
Pause/Resume
button The Pause/Resume button is used to pause the Printer during normal
operation and also to resume operation after an error condition is
cleared.
Note #1: In general, as the icon above this button indicates, errors are
related to either the ribbon or the cards. If an error occurs, the Media LED
will flash.
Note #2: The Printer must have both the Power LED and the Media LED
illuminated in order to print. See
Reviewing the LCD Error/Status
Messages in section 2, page 22 for more information.
Card Cleaning
Roller This roller automatically cleans cards for higher print quality. (Note:
Clean the Card Cleaning Roller during every ribbon change (every 250
cards) or as needed.)
Card Input
Hopper Load blank cards into this Hopper.
Power Port This port connects to the (included) power cord.
Parallel
Interface Port This port connects to a Windows PC with a parallel cable.