Cover removal, Replacing the rear cover (d810054), Refer to drawings 830117, 830118 and 830119 – FARGO electronic C16 User Manual
Page 171: Replacing the top cover (d810044)
RESTRICTED USE ONLY
Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0)
162
Cover Removal
Replacing the Rear Cover (D810054)
Refer to Drawings 830117, 830118 and 830119.
Tools Needed: Phillips Head Screwdriver. Estimated Repair Time: 15 minutes.
Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2
Open the Upper Imaging Assembly.
3
Loosen the top two corner screws (130987) found just behind the top edge of the
Rear Cover.
4
Close the Upper Imaging Assembly.
5
Remove the screw (130987) by the Card Exit Ramp.
6
Remove the Rear Cover.
Replacing the Top Cover (D810044)
Estimated Repair Time: 5 minutes.
Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2
Open the Upper Imaging Assembly.
3
Remove the screws (130948) from the four corners of the top cover.
4
Close the Upper Imaging Assembly.
5
Lift the top cover from the Printer