FARGO electronic C16 - Manual (Page 201)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0) 192
Replacing the Card Feed Roller (D830024) (continued)
Steps Procedure
15 Remove the Retainer Clip (130950) from the Card Feed Roller Shaft on the rear
of the Chassis Assembly
16 Remove the screws that hold the Card Feed Motor in place.
17 Remove the Card Feed Motor.
18 Remove the Drive Gear from the roller shaft.
19 Remove the Drive Roller Bearing (760343) from the front Side plate.
20 Slide the Card Feed Roller forward — away from the rear Side plate.