FARGO electronic C16 - Manual (Page 13)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0) 4
Safety Messages (review carefully) _______________________________________ 148
Using the Required Supplies __________________________________________ 149
Cleaning Procedures___________________________________________________ 150
Cleaning the Printhead _______________________________________________ 150
Cleaning the Card Feed and Cleaning Rollers _____________________________ 151
Cleaning the Platen Roller ____________________________________________ 153
Cleaning the Printer's Interior _________________________________________ 154
Section 5: Parts Replacement____________________________________________ 155
Safety Messages (review carefully) _______________________________________ 155
Reviewing the Printer Components _______________________________________ 156
Reviewing the Front Cover Components_________________________________ 156
Reviewing the Back End Components___________________________________ 157
Reviewing the Rear Side plate Components ______________________________ 158
Reviewing the Print Board Components _________________________________ 159
Reviewing the Print Area Components __________________________________ 160
Reviewing the Main Print Board Connections_____________________________ 161
Reviewing the Power Board Connections ________________________________ 161
Cover Removal_______________________________________________________ 162
Replacing the Rear Cover (D810054) ___________________________________ 162
Replacing the Top Cover (D810044)____________________________________ 162
Replacing the Front Cover (D810001)___________________________________ 163
Board, Interface and Printhead Replacements _______________________________ 164
Replacing the Print Circuit Board (D810059) _____________________________ 164
Replacing the Power Circuit Board (A000284) ____________________________ 165
Replacing the Printhead Assembly (081524)______________________________ 166
Replacing the Printhead Harness Assembly (830162-00) ____________________ 167
Replacing the Front Panel Board Assembly (A000265) _____________________ 169
Motor and Mag Head Replacements ______________________________________ 170
Replacing the Headlift Motor Assembly (830143) _________________________ 170
Replacing the Card Feed Motor Assembly (830145) _______________________ 171
Replacing the Ribbon Drive Motor Assembly (830147) _____________________ 172
Replacing the Stepper Motor assembly (810113) __________________________ 173
Securing the current Stepper Motor Bracket and Fastener for increased belt tension174
Replacing the Magnetic Head Assembly (High-Coercivity: 810182 or Low-
Coercivity: 810182) _________________________________________________ 175
Sensor Replacement ___________________________________________________ 177
Replacing the Card Sensor Assembly (830135) ___________________________ 177
Replacing the Upper Ribbon Sensor Assembly (83015111) __________________ 178
Replacing the Encoder Wheel Sensor Assembly (830149) ___________________ 180
Replacing the Lid Sensor Assembly (810174) ____________________________ 181
Replacing the Ribbon ID Sensor Board Assembly (820543) _________________ 182
Replacing the Lower Ribbon Sensor Assembly — C16 (83012612) ___________ 184
Roller Replacement ___________________________________________________ 185
Replacing the Platen Roller (D830023) __________________________________ 185
Replacing the Card Feed Roller (D830058) - Center________________________ 187
Replacing the Card Feed Roller (D830058) – Left _________________________ 189