FARGO electronic C16 - Manual (Page 85)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0) 76
Adjusting for CR-79 Adhesive Back Cards (continued)
Step Procedure
1 If you are loading CR-79 cards, this guide must be adjusted to accommodate this
smaller, thinner card stock.
a. Open the Printer's Top Cover.
b. Move the Adjustment Lever back, over and down into the CR-79 position to
narrow the card path (so it holds these smaller cards more securely). (Note:
The Internal Card Guide only moves a slight distance. This position is critical
for maintaining sharp image registration.)
c. Be sure to always set this adjustment lever according to the card size already
loaded in the Printer.
The CR-79 Position (used to adjust only if printing CR-79 sized cards) is displayed below.