FARGO electronic C16 - Manual (Page 88)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0) 79
Using the Image Darkness option
Use this option to set the overall darkness of the printed image by increasing or decreasing
the amount of heat used by the Printhead when printing.
Step Procedure
1 Lighten the printed image by clicking the down arrow to enter a negative
value and decrease the amount of Printhead heat.
OR
Darken the image by clicking the up arrow to enter a positive value and
increase the amount of Printhead heat.
Maximum Adjustment Range: The maximum adjustment range is ±100.
Caution #1: For best results, make slight adjustments of only ± 4 to
avoid accidentally over-adjusting the Printhead heat.
Caution #2: If the positive value is set too high, the print ribbon may
jam or even break.
Using the Image Placement option
Use this option to adjust the lengthwise or horizontal position of the printed image on a card
so it appears centered. (Note: When adjusting this value, keep in mind that cards always
remain in the same landscape orientation while moving through the Printer.)