Muratec MFX-2830 - Manual (Page 277)

FAX Chapter2 ● Advanced Fax Features
Getting
Started
COPY
Chapter1
COPY
Chapter2
COPY
Chapter3
FAX
Chapter1
FAX
Chapter2
FAX
Chapter3
FAX
Chapter4
Common
Settings
In This
Case...
Appendix
3-99
Performing F-Code Communications
Functions used with F-code communications
Utilizing sub-addresses and passwords enables you to use the following functions.
◆ F-code security box communications
When the other party for communications has an F-code security box set, F-code security communications can
be performed by specifying the sub-address and the password (if necessary) for that box.
Unless the receiver of the security box communication inputs a specific I.D. code, the received document cannot
be printed out, which is essential for sending highly confidential documents.
· F-code security box transmissions ........................Transmissions using sub-addresses (see page 3-116)
· Receiving F-code security box communications ...Printing stored documents (see page 3-122)
Reference
◆ F-code bulletin box communications
When the other party for communications has an F-code bulletin box set, documents can be sent to the bulletin
box. The stored documents in the bulletin box can be retrieved (polling) by specifying the sub-address of that
box. (Password specified as necessary)
· Sending documents to another party’s bulletin box ...................Transmissions using sub-addresses (see page 3-116)
· Retrieving documents stored in another party’s bulletin box ...Reception using sub-addresses (see page 3-118)
· Storing documents in your bulletin box ......................................Storing documents in bulletin boxes (see page 3-120)
Reference
◆ F-code relay command communications
When an F-code relay box has been set in a relay machine, specifying the sub-address of that box can perform
relay command communications. (Password specified as necessary)
At the relay machine, specified documents are sent (distributed) to the receiving party (distribution destina-
tion) registered in the box.
· Transmitting relay commands ................................. Perform F-code transmissions after first checking the sub-address of
and password to the relay command communications box that are set
in the other fax machine. (see page 3-116)
· When this machine is used as the relay machine ...Set the relay box by registering F-code boxes (see page 3-100).
Reference