Muratec MFX-2830 - Manual (Page 452)

In This
Case...
In This Case... ● Maintenance and Troubleshooting
5-32
■
Copy-Related
Error message Countermeasure Reference page
ADF is unavailable. Set the docu-
ment on the FBS glass. A document has been placed in the ADF during series copy. Set the
document on the document glass. 2-44
Cannot use bypass tray for duplex
copy The bypass tray cannot be used for duplex copies. Choose a cas-
sette. 1-32
Enter hold time The “last job hold time” is set to 0 minute. The hold time needs to
be set to use the last job function. 2-64
Enter reduce/enlarge Custom paper cannot be copied with an automatic zoom ratio. En-
ter reduce/enlarge ratio. 2-18
Load paper in bypass tray The paper in the bypass tray has run out. Supply paper to the by-
pass tray. 1-32
Load paper for duplex copying
Paper inappropriate for duplex copy
Duplex copy is not available for the paper mentioned in the mes-
sage. Select another type of paper. 2-67
No Document stored in memory The last job document has been deleted because a lot of memory
was used for reservations and proxy reception. 2-64
Not enough memory The document could not be accepted due to insufficient memory.
Set the document again after the current operation finishes.
Not enough memory
The last %1 page was erased
Please copy again Copying was interrupted due to insufficient memory. Restart copy-
ing from the displayed page.
Option not valid with.... Attempting to combine a function which cannot be set at the same
time with ... Re-enter the setting. 2-88