Muratec MFX-2830 - Manual (Page 290)

FAX
Chapter2
FAX Chapter2 ● Advanced Fax Features
3-112
To change the settings of F-code boxes...
Repeat the setting process, pressing [Clear] to delete information you want to change, and then enter the new settings.
To change the box type...
Delete the F-code box you want to change, then register it again.
In this case
■ Entering an I.D. code
Relay Box
Select item to edit.
Enter 2/2
I.D.Code :
(1) Press [ ] [ ], then press
[I.D.Code].
Relay Box
Enter I.D.Code/password
Enter 2/2
I.D.Code :
Clear
Enter I.D.Code
****_
Cancel
(2) Enter the I.D. code (4 digits)
using the numeric keypad,
then press [Enter].
6
To continue to register other
F-code boxes, press [Enter], then
repeat from step 5 of “Registering
F-code boxes” on page 3-100.
If you enter an incorrect
code, press [Clear] to de-
lete it and then enter the
correct one.
Note
Press RESET to return to
the standby screen.
Note
I.D. code must be entered
to print out stored docu-
ments, etc. Make a record
not to forget it.
Note