Muratec MFX-2830 - Manual (Page 451)

In This Case... ● Maintenance and Troubleshooting
Getting
Started
COPY
Chapter1
COPY
Chapter2
COPY
Chapter3
FAX
Chapter1
FAX
Chapter2
FAX
Chapter3
FAX
Chapter4
Common
Settings
In This
Case...
Appendix
5-31
Error Message
Error message Countermeasure Reference page
Please set up Security Rx Attempting the security reception without setting. Perform the se-
curity reception setting first. 3-88
Received document stored Attempting to cancel Security reception when a Security reception
document is present.
Print the received document. 3-90
Scanner in use One or more of the following operations was attempted when the
scanner was in use. Wait until the scanning finishes before at-
tempting the operation.
· Transmission to a different destination.
· Storing a document reserved for polling.
· Attempted to change the resolution or contrast.
Security reception document pres-
ent During security reception. Print the received security reception
document. 3-90
Selected address is invalid The recipient for the reserved transmission has not been regis-
tered yet.
Set Fax/Tel Ready Mode · Attempting to turn on all fax forward settings in Tel mode. Fax
forward cannot be used in Tel mode.
· Call forward cannot be used in this reception mode. When using
call forward, set the reception mode to Fax/Tel or Tel/Fax.
1-54
Set individual forwarding numbers
first No recipient has been registered for fax forwarding, or no regis-
tered recipient has been set to On. Set at least one recipient On for
forwarding faxes. 3-80
Set ratio below 400% A ratio more than 400% was specified for enlarge transmission ra-
tio. Reset the number between 100% and 400%.. 3-132
The value entered exceeds the limit
Please enter a value within the list
range The entered ratio is incorrect. Enter the correct ratio again. 3-132
Too many characters Names or numbers were entered exceeding the maximum limit.
Re-enter within the maximum number of characters.
Too many locations The number of department codes exceeded 100.
Up to 100 department codes can be registered. 4-14
To stop transmission
Press FAX CANCEL key Pressed STOP during fax transmission. Cancel the transmission by
FAX CANCEL/JOB CONFIRM .
3-28