Muratec MFX-2830 - Manual (Page 449)

In This Case... ● Maintenance and Troubleshooting
Getting
Started
COPY
Chapter1
COPY
Chapter2
COPY
Chapter3
FAX
Chapter1
FAX
Chapter2
FAX
Chapter3
FAX
Chapter4
Common
Settings
In This
Case...
Appendix
5-29
■
Fax-Related
Error Message
Error message Countermeasure Reference page
ADF used in feeder command One or more of the following operations was attempted either dur-
ing real-time transmission or when real-time transmission was
reserved.
· Press
STOP .
· Transmission to a different destination was instructed.
· To store a document reserved for polling was instructed.
Wait for the real-time transmission to finish, or cancel the reser-
vation for real-time transmission before operating the unit.
3-28
Already stored The same number has already been entered. Check the number
and re-enter it.
Cannot select mode during Fax &
Copy Attempting to change to the fax screen during Fax & Copy. Change
to the fax screen after Fax & Copy finishes. 3-128
Cannot store in security box The box selected for F-Code document storage or deletion is a se-
curity box. Select a bulletin box. 3-120, 3-124
Cannot use numeric keypad Attempting to enter a direct dial number for a location using the
F-Code box relay box. Enter the location using the one-touch key,
the speed-dial, or a group number. The numeric keypad cannot be
used. 3-109
Command is full The number of reserved command has exceeded 100. Up to 100 re-
served commands can be registered.
Wait until the current reserved operations are completed before
attempting the operation. Or, use real-time transmission.
3-5
Communication error A communication error occurred. Check the contents of the com-
munication error and repeat the operation.
Press
STOP if the “Communication error” does not disappear.
5-24
Document full Registered 40 or more documents in the box designated for batch
transmission. Print out the batch transmission document list.
Check the registered documents to make the number of documents
less than 39 by deletion. 3-70
3-71
Document stored A polling reservation has already been stored. Normally, only one
polling reservation can be stored. 3-92
Batch transmission has been stored. When a batch transmission
has been stored, the batch transmission box cannot be deleted. 3-68
Enter sub-address No sub-address has been entered in the F-Code box. Enter the sub-
address. 3-98
Incorrect passcode Entered an incorrect passcode. Enter the correct passcode. 4-36
Input ratio (100-400%) A ratio less than 100% was specified for enlarge transmission ra-
tio. A reduction ratio cannot be specified, so reset the number to
larger than 100%. 3-132
Invalid I.D. code This message is displayed when you entered an incorrect I.D. code
in printing the document stored in F-code Box. Enter the correct
I.D. code. 3-102