PIONEERPOS AT Commands G24-LC - Manual (Page 107)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-43
+MCST Parameters
The following table shows the +MCST parameters.
Example
AT+MCST?
+MCST: // <idle>
AT+MCST=1
OK
atd035684423;
+MCST: 17
OK
+MCST: 17
+MCST: 255
OK
+MCST: 3
+MCST: 17
NO CARRIER
+MCST: 1
Table 3-20: +MCST Parameters
<Parameter> Description
<n> 0 - Disable MCST unsolicited indication
1 - Enable MCST unsolicited indication
<state> 1 - Idle call state
2 - Single incoming call
3 - Single call active
4 - Multi-party call active
5 - Single call held
6 - Multi-party call held
7 - Dual call (fully connected active call and held call)
8 - Dual multi-party call active
9 - Dual multi-party call held
10 - Single active call plus call waiting
11 - Multi-party call active plus call waiting
12 - Single call held plus call waiting
13 - Multi-party call held plus call waiting
14 - Dual calls plus call waiting
15 - Dual multi-party calls active plus call waiting
16 - Dual multi-party calls held plus call waiting
17 - Call control busy
64 - Calling
68 - No Service
69 - No Redial
72 - Security Fail