PIONEERPOS AT Commands G24-LC User Manual
Page 191
Chapter 3: AT Commands Reference
April 15, 2008
G24-L AT Commands Reference Manual
3-127
This command is a non-basic command, which means that the G24-L module rejects the
command with an appropriate error message when the SIM is not present and/or the phone is in
lock state.
Command Type
Syntax
Response/Action
Remarks
Set
+MFS=<freq>
[,<mode>]
OK
or:
+CME ERROR: <err>
This command enables you to change
and store in Flex the new values of
Frequency of Search <freq> and
Search mode <mode>.
If only the <freq> value is given, then
the Set command is interpreted as
follows:
• Store new <freq> value. The
<mode> value remains unchanged.
If <freq> and <mode> values are
given, then the Set command is
interpreted as follows:
• Store new <freq> and <mode>
values.
Otherwise, an error message is sent to
the DTE.
Note:
If the phone is not registered,
then a set operation of Search
mode to Manual is refused and
ERROR is sent to the DTE.
Read
+MFS?
+MFS: <freq>,<mode>
OK
or:
+CME ERROR: <err>
The Read command returns the current
settings for values of <freq> and
<mode>.
Test
+MFS=?
+MFS: (List of
supported <freq>,(List
of supported <mode>s)
OK
or:
+CME ERROR: <err>
The Test command returns the possible
<freq> and <mode> values.