PIONEERPOS AT Commands G24-LC - Manual (Page 329)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-265
The following table shows the +MTKP parameters for response code 26.
Note: When STK proactive commands are disabled by the TE, MTKP unsolicited events are not
issued to it. In such a case, the Launch Browser command is rejected with the result value
"Browser unavailable".
The diagram below demonstrates the communication during Launch Browser command.
Figure 3-15: Communication During Launch Browser Command
Set Up Event List
The SIM card uses this command to supply a set of events, which becomes the current list of
events for the G24-L to monitor, replacing any existing list. This command can also be used to
remove the list of events. The list of events provided by the SIM is erased if the G24-L is
powered down, or if the SIM is removed or electrically reset. When one of the events in the
current list occurs, the G24-L uses the Event Download mechanism to transfer event details to the
SIM.
Table 3-187: +MTKP Parameters – Response Code 26
<Parameter> Description
<result> 0 Success
1 Failure
<additional
info> 0 No specific cause can be given
1 Bearer unavailable
2 Browser unavailable
3 G24-L unable to read provisioning data
Note: Additional info should be added only in case of failure.
<err> 1 Unknown result value.
Launch Browser
+MTKP: 26,<URL>,<bearers>,
<proxyld>,[alphald>]
AT+MTKP=26,<Result>,
[<additional info>]
Launch Browser Response
SIM ME TE