PIONEERPOS AT Commands G24-LC - Manual (Page 430)

Acr & Abbr-2 G24-L AT Commands Reference Manual April 15, 2008
C CTS RS232 pin used for HW flow control. The MGOM uses this pin to stop data transmission
from the DTE (on the TXD pin).
D DA Destination Address
D DCD Data Carrier Detect
D DCE Data Communication Equipment (G24)
D DCSs Data Coding Schemas
D DLC Data Link Connection
D DLC0 The multiplexer control channel.
D DLCI Data Link Connection Identifier
D DSP Digital Signal Processor
D DSR Data Set Ready
D DSR MGOM is ON and ready to communicate with the DTE device.
D DT Discharge Time
D DTE Data Terminal Equipment (such as terminals, PCs and so on). Also called Application
Processor (AP).
D DTMF Dual-Tone Multi-Frequency
D DTR Data Terminal Ready
E EF Elementary Files
E EONS Enhanced Operator Name String
E ERM Error Recovery Mode
E ESC Exit to Command Mode from Data Mode (usually the +++ sequence)
E ETSI European Telecommunication Standards Institute
F FCC Federal Communications Commission (U.S.)
F FO First Octet
F FTA Full Type Approval
G GCF GSM Certification Forum
G GGSN Gate GPRS Support Node
G GPIO General Purpose Input/Output
G GPRS General Packet Radio Service
G GRLC General RS232 Logical Channel - This channel can handle the 07.07/07.05 AT command
set (CSD, FAX, GPRS, Voice, Network AT, and so on.)
G GSM Global System for Mobile Communications
Abbreviation Full Name
D
E
F
G