PIONEERPOS AT Commands G24-LC - Manual (Page 215)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-151
The following table shows the +MMAD parameters.
Unsolicited
Messages AT+MMAD=<Conver
ter_number>
Case:
*. Average calculation
isn't active :
*. Average calculation
is active:
+MMAD:
<Converter_number>,
<Converted_Value> OK
+MMAD:
<Converter_number>, <Average>
OK
If <Report> value is - 3,
the report will be generated
according to report interval
value. If <Report interval>
value was not set, there
will be no messages, but
you can ask for a solicited
message.
Command
Type Syntax Response/Action Remarks
Table 3-98: +MMAD Parameters
<Parameter> Description Range/Remark
<Converter
Number> 1-5 Select the A2D converter.
<Report> 0 Unsolicited report is not active/ stop unsolicited report &
deactivate +MMAD operation.
1
Unsolicited report in active for all A2D conversion events.
2 Unsolicited reports are active only for out off boundaries events.
3 "Average report" - send periodic average.
Optional for Average
calculation.
<Rate> 1-255 Select the time interval between two samples.
Units:
100 milli Sec - in case of average computation.
Seconds - in case of A/D sampling only. 100mili - for average;
sec-Otherwise.
Mandatory for Average
calculation.
<low>,<High> 0,230 or 300,450 A decimal value represents the digital value.
Low - The lowest boundary level of digital value.
High - The Highest boundary level of digital value.
Default value for converters 1-3 is 0,230.
Default value for converter 5 is 300,450.
<Converted
Value> A decimal value represents the returned digital value.
For converters 1-3 and 5, the returned value represent the input level
multiplied by 100.
<Num_of_sam
ples> 2 - 255 The number of samples that are used for average calculation. Mandatory for Average
calculation.
<Average_calc
_duration> 1 - 255 For how long the average calculation will be active.
0 - Not active.
255 - Endless.
1...254 - minutes. 1- Default value if average is
active.
While not active = 0.